BigJimny Meet 2019 (17 May 2019)

BigJimny Meet and off-road driving day



If you have booked you will shortly receive joining instructions- See HERE for discussion

Noggin and Natter - pre-event chat - Old Bell at Grazeley (part of hotel) 7:30pm 19th October

× A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.

Jimny Radius Arm Mounting Guards

16 Sep 2019 21:16 #213584 by wjamieson
I'm looking for some Jimny Gen 4 Radius Arm Mounting Guards. Struggling to find any specifically identified as suitable for Gen 4. Does anyone know whether the Gen 3 guards fit Gen 4? I have seen two different models. One with a lug at one end which fits into a hole in the chassis with only one bolt. No drilling required. Alternatively there is the style like at Big Jimny which requires some minor drilling. Prefer not to drill if possible.

Anyone fitted to Gen 4? Any recommendations?

Thanks in advance.
The following user(s) said Thank You: CC Baxter

Please Log in or Create an account to join the conversation.

17 Sep 2019 01:51 #213589 by CC Baxter
Good question, I'm looking for a set of these. I'll bet someone's already fitted some.

Please Log in or Create an account to join the conversation.

Moderators: funkyjimnyooky_123
Time to create page: 0.054 seconds
Powered by Kunena Forum

I hope you enjoy using this forum. Please consider making a donation towards the upkeep of this forum website.