The owner and site administrator of BigJimny

First proper test run

jimny
We took a little test run out today, just a few green lanes around the area to see how she runs. The lanes are generally in very good condition around here following the local council putting down a loose surface on them a few years back. Therefore they are not taxing but there is enough mud and ruts to bounce the suspension around and to require 4...
Continue reading
  1056 Hits
Tags:
1056 Hits
0 Comments

Interior refit

sized_Jimny_IMG_20171210_154635

 So with the MOT passed, we have been driving around this week. Unfortunately, there is a vibration or "push" in the drivechain. I took the rear propshaft off and found the UJs were notchy and very stiff. Taking them apart showed not only rusted out UJs but also a bent yoke. So a new yoke is on order and the car is back in bits in the garage. However this time is it only short lived and I took the opportunity to get on with the interior.

Continue reading
  1000 Hits
Tags:
1000 Hits
0 Comments

Into the light!

Jimny_IMG_20171125_140126

​With everything coming together it is time to leave the garage for the first time in 4 years!

Continue reading
  914 Hits
Tags:
914 Hits
0 Comments

A few more tweaks

regal2250_IMG_20171118_181938

When I started her up for the first time, I noticed a couple of problems. The first was the engine management light (EML) on whilst the second was a stream of water and clouds of steam from the exhaust. 

Continue reading
  889 Hits
Tags:
889 Hits
0 Comments

Wheel bearing

Jimny_IMG_20171121_184231

 Whilst re-building the front axle I noticed that the offside wheel bearing was really rough. It needed changing so off came the hub for a quick change. I originally documented a wheel bearing change HERE so this is more a quick update on changing it again.

Continue reading
  908 Hits
Tags:
908 Hits
0 Comments